1930 Cadillac Brochure Front Cover - GM Heritage Center
1930 Cadillac Brochure Front Cover - GM Heritage Center
1930 Cadillac Brochure Front Cover - GM Heritage Center
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
52 CADILLAC OPERATOR'S MANUAL<br />
Before starting the engine, drain the oil from the oil pan and remove<br />
and clean the oil pan and screen. After reinstalling the oil pan, add eight<br />
quarts of fresh engine oil. Fill the cooling system, being sure to use antifreezing<br />
solution in freezing weather. Remove the spark plugs and inject<br />
two or three tablespoonfuls of engine oil into each cylinder. Reinstall the<br />
spark plugs and, with the ignition switched off, crank the engine a few<br />
seconds with the starter to distribute the oil over the cylinder walls.<br />
Start the engine in the usual manner. As soon as the engine starts, immediately<br />
let the carburetor enriching button go as far forward as possible<br />
without causing the engine to stop or slow down materially, and then<br />
open the throttle until the ammeter reads approximately 10 with all lights<br />
switched off. While the engine is running, lift the aluminum cap on top<br />
of the carburetor and inject two or three tablespoonfuls of engine oil into<br />
the carburetor. It is a good plan to run the car outdoors as soon as this<br />
has been done. Release the carburetor enriching button entirely as soon<br />
as the engine is warm enough to permit it.<br />
Type of engine<br />
CHAPTER VIII<br />
Specifications and License Data<br />
8 cyl. V-type<br />
Diameter of cylinder bore<br />
3?s in.<br />
Length of stroke<br />
4 1 ¾ in.<br />
Piston displacement 353<br />
Horsepower (N. A. C. C. rating) 36.45<br />
Engine number<br />
See below<br />
Capacity of gasoline tank<br />
25 gals.<br />
Capacity of engine lubricating system<br />
2 gals.<br />
Capacity of cooling system<br />
6 gals.<br />
Capacity of transmission<br />
3 qts.<br />
Capacity of rear axle V/i q ts -<br />
Wheelbase<br />
140 in.<br />
Tires 7-00-19<br />
Valve setting, inlet<br />
004 in.<br />
Valve setting, exhaust<br />
006 in.<br />
Spark plug setting<br />
025-.028 in.<br />
Contact point setting<br />
024 in.<br />
) 18-20 amps, cold<br />
Generator charging rate, maximum ^ 8_ 10 a m p s h o t<br />
Fan belt slack<br />
1 in.<br />
<strong>Front</strong> axle toe-in<br />
Vs to M in.<br />
Engine and Unit Assembly Numbers<br />
Each <strong>Cadillac</strong> car, when shipped, carries an engine number, which is<br />
also a serial number. This is the number to be used in fillingout license<br />
and insurance applications and in general reference of the car. The engine<br />
number is stamped on the crankcase just below the water inlet on the righthand<br />
side.<br />
The various units, such as the transmission, steering gear, etc., also carry<br />
unit assembly numbers. These are located as described below. It is im-<br />
(53)