HV-HD201 Op Manual - Hitachi Kokusai Electric America, Ltd.

15. COLOR DETAIL
The amount of an contour enhancement can be set in the specified
range of hue.(Ch1, CH2 can be set independently).
1) COLOR DETAIL : Selects color detail mode
• OFF : Color detail is ineffective.
• CH1 ON : Only CH1 is effective (CH2 is ineffective).
• CH2 ON : Only CH2 is effective (CH1 is ineffective).
• CH1&CH2 ON : CH1 and CH2 both are effective.
COLOR DETAIL [FILE1 ]
COLOR DETAIL :OFF
CH1 A.PHASE :[PUSH R] 1SEC
PHASE : 0 Ye-R
WIDTH : 0
LEVEL :-128
CH2 A.PHASE :[PUSH R] 1SEC
PHASE : 0 Ye-R
WIDTH : 0
LEVEL :-128
2) CH1 A. PHASE : Automatic detection of hue of CH1 color detail.
CH2 A. PHASE : Automatic detection of hue of CH2 color detail
INITIALIZE :[PUSH L+R] 2SEC
When the cursor is moved to this item, the detection mark is
displayed at the center of the screen. Move this mark to a portion of the subject in your target color.
Then, press the R button for 1 second. The hue of this area is automatically detected and set to phase.
3) PHASE : Sets hue of color detail
Hue is shown by 6 areas and numerical value of -128~127.
(When cursor is at this item, mark is display at the corresponding part and range to set hue.)
4) WIDTH : Sets range for the hue set in PHASE
Setting range is -128 to 127. Press button R for wide region and L button for narrow region.
(When cursor is at this item, mark is display at the corresponding part and range to set hue.)
5) LEVEL : Sets color detail level
Range is -128 (soft) to 127 (sharp). Press both L and R for about 2 seconds to set to 0.
6) INITIALIZE : Initializes DETAIL menu settings to factory setting.
Press L and R buttons simultaneously for about 2 seconds. (Only the selected scene file is initialized.)
37