MA-500TR Instruction Manual - ICOM Canada
MA-500TR Instruction Manual - ICOM Canada
MA-500TR Instruction Manual - ICOM Canada
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4<br />
BASIC OPERATION<br />
■ Turning power ON<br />
IMPORTANT: BE SURE to connect the GPS receiver to<br />
the transponder before turning the power ON. (p. 35)<br />
q Hold down [POWER•BRILL] for 1 second to turn ON the<br />
power.<br />
• A long beep sounds, and the opening screen appears.<br />
e After the opening test is completed, the MMSI code appears,<br />
if the code has already been set.<br />
• “No MMSI” appears when no MMSI code is set. (p. 7)<br />
[POWER•BRILL]<br />
w The opening screen displays the results of the ROM, RAM<br />
and backup data test, “OK” or “NG” (No Good).<br />
• If “NG” is displayed, hold down [POWER•BRILL] for 1 second to turn<br />
OFF the power, then ON again to reset the transponder. If there is no<br />
change, contact your dealer or service center.<br />
r The GPS search display appears while searching for a<br />
GPS satellite.<br />
• While searching, the GPS information screen can be displayed<br />
by pushing [ENT], or you can enter the Menu mode by pushing<br />
[MENU]. (pp. 28, 31)<br />
14<br />
t When the GPS receiver receives signals from a satellite,<br />
the transponder automatically displays the position data<br />
on the plotter display. (p. 15)
Change language