LM 286 EN 30012013.book - Oy LAIMU Ab
LM 286 EN 30012013.book - Oy LAIMU Ab
LM 286 EN 30012013.book - Oy LAIMU Ab
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
User manual <strong>LM</strong> <strong>286</strong><br />
1.2.2 During operation<br />
1.2.3 After operation<br />
• Keep the machine clean. Accumulated soil, grease, dust and grass may<br />
ignite and cause accidents.<br />
• Only use additional equipment and tools approved by <strong>Oy</strong> <strong>LAIMU</strong> <strong>Ab</strong>.<br />
• Check before starting the machine that it has enough fuel and oil, and<br />
that it is lubricated and all maintenance procedures have been carried<br />
out.<br />
• Do not alter the structure of the machine. It may lead to unpredictable<br />
safety risks.<br />
• Do not let an inexperienced person operate the machine. The person<br />
lending the machine is responsible for possible damage and accidents.<br />
• Enter and exit the machine is a safe way. Always use the handgrips and<br />
steps. Never grab the controls when entering the machine. Never<br />
jump up to or down from the machine.<br />
• Start and operate the machine only from the driver's seat. Never stand<br />
up from the seat while the engine is running.<br />
• Before starting the machine, check that all controls are in neutral<br />
position or off.<br />
• Do not start the engine by shorting the starter connectors. Do not try<br />
to bypass the ignition switch, as the machine may start moving.<br />
• Do not start the engine in a closed or poorly ventilated space. Exhaust<br />
gas is toxic.<br />
• Ensure that all safety equipment and hatches are in place. Replace<br />
damaged or missing safety equipment.<br />
• Prevent the machine from being tilted. Adjust your speed to the<br />
prevailing conditions and do not drive on slopes that are too steep.<br />
• Keep the doors and hatches closed while driving. Do not steer the<br />
machine from outside the cabin.<br />
• Use the controls in a safe manner. Press the accelerator pedal slowly to<br />
prevent jerky starting of the machine.<br />
• Plan your route, avoid obstacles.<br />
• Keep a safe distance from trenches and steep slopes. Be especially<br />
careful in rain and when driving on a wet or icy/snowy surface.<br />
• Pay attention to other traffic! Watch where you are heading and use<br />
the roof beacon as required by local traffic legislation and decrees.<br />
• Remember that the stability of the machine changes according to the<br />
load. Keep loads as low as possible.<br />
• When driving downhill, let the power train do the braking. Avoid using<br />
the brake pedal to reduce your speed.<br />
• Do not change your course or speed while driving on slopes.<br />
• Keep hold of the steering wheel if the machine tilts, do not jump.<br />
• Carefully follow the operating and safety instructions of tools.<br />
• Do not go into the turning area of the machine's body link (336–686<br />
machines) while the engine is running, as you may be crushed.<br />
► Park the machine on hard level terrain.<br />
► Lower all tools onto the ground.<br />
► Stop the engine.<br />
► Remove the ignition key.<br />
► Lock the doors.<br />
► Open the main power switch.<br />
6 02 Safety Rev. 30.1.2013