LM 286 EN 30012013.book - Oy LAIMU Ab
LM 286 EN 30012013.book - Oy LAIMU Ab
LM 286 EN 30012013.book - Oy LAIMU Ab
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>LM</strong> <strong>286</strong><br />
User manual<br />
4.8.4 Using the bonnet/platform body<br />
Figure 37.<br />
The bonnet/platform body can be tipped by opening the latch (A) and turning it<br />
as shown in the figure. Always ensure that the bonnet is tipped to its extreme<br />
position, if you are working underneath it.<br />
Varoitus! Varning! Warning!<br />
After closing the bonnet/platform body, remember to check that you<br />
lock it with the latch!<br />
Varoitus! Varning! Warning!<br />
Ensure that the bonnet/platform body is tipped to its extreme position,<br />
if you are working underneath it!<br />
4.9 Tools with hydraulic motor operation<br />
Tools with hydraulic motor operation can be attached to the front of the<br />
machine.<br />
The hydraulic output of the tool installed at the front cannot be adjusted<br />
as such, but can be affected by changing the engine revolutions with the<br />
hand throttle.<br />
Hydraulic output to the front/rear output<br />
Engine revolutions Output (approximate)<br />
1,000 r/min 17 l/min<br />
2,000 r/min 34 l/min<br />
3,000 r/min 51 l/min<br />
Table: 6<br />
Huomaa! Notera! Note!<br />
Always remember to check the highest permitted output from the tool<br />
manual or type plate.<br />
Never exceed the highest permitted output of the tool.<br />
Whenever possible, use the lowest possible output of the tool (by<br />
adjusting the engine revolutions).<br />
Rev. 30.1.2013 05 Driving and use 35