LM 286 EN 30012013.book - Oy LAIMU Ab
LM 286 EN 30012013.book - Oy LAIMU Ab
LM 286 EN 30012013.book - Oy LAIMU Ab
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
5.13 Machine storage<br />
User manual <strong>LM</strong> <strong>286</strong><br />
5.13.1 Short‐term storage for less than 2 months<br />
No special actions are required, if:<br />
• The machine has been regularly serviced.<br />
• The machine is clean.<br />
• The coolant's resistance to freezing is sufficient for the prevailing<br />
temperature.<br />
• The fuel tank is full.<br />
• Appropriate storage for the battery has been arranged.<br />
5.13.2 Long‐term storage for more than 2 months<br />
The following procedures are required, if the machine is left in storage<br />
for over 2 months:<br />
► Clean the machine from inside and out and carry out general lubricating<br />
procedures.<br />
► Clean the engine air filter case and element.<br />
► Drain and flush the cooling system, and fill it with the recommended antifreeze<br />
mixture.<br />
► Open the fuel filter drain tap, and let out any water and deposits. Close the<br />
tap.<br />
► Clean and pour 5 l of protective fuel or 1.5% oil into the fuel tank.<br />
► Fill the tank with clean fuel.<br />
► Let the engine run until it reaches normal temperature, and drive the<br />
machine for a while.<br />
► Raise the front lifter to the up position.<br />
► Change the engine oil and filter.<br />
► Disconnect the nozzles and pour approximately 0.5 dl of protective oil into<br />
every cylinder. Rotate the engine with the starter for a moment (the stop<br />
lever in the engine bay must be in the STOP position).<br />
► Connect the nozzles and use new seals.<br />
► Loosen the fan belt.<br />
► Protect easily rusting parts with protective oil (CRC or similar).<br />
► Cover the air filter and exhaust pipe openings with plastic film.<br />
► Disconnect the battery cables.<br />
► Ensure that the battery is fully charged. If the machine is stored in a cold<br />
environment, remove the battery from the machine. Check the battery<br />
charge every 30 days.<br />
► Store the machine in a dry, warm space, and protect it against sunlight.<br />
► To prevent rust, grease all exposed cylinder shafts.<br />
5.14 Machine commissioning<br />
5.14.1 After storage of less than 2 months<br />
► Check that the battery is fully charged.<br />
► Check the oil and fluid levels and tyre inflation pressures.<br />
► Perform general lubrication.<br />
► Bleed the fuel system if necessary.<br />
► Start the engine, but do not over rev it.<br />
► Do a test drive to make sure that all equipment functions normally.<br />
5.14.2 After storage of more than 2 months<br />
► Remove the protective covers and lower the machine.<br />
► Remove the plastic film from the exhaust pipe and intake air opening.<br />
► Check tyre pressures.<br />
► Open the fuel filter drain tap, and let out any water and deposits. Close the<br />
tap.<br />
► Check the engine oil level.<br />
► Check the coolant level.<br />
► Check that the battery is fully charged.<br />
► Lubricate the battery terminals, connect the battery clamps and tighten<br />
them properly.<br />
► Perform general lubrication.<br />
► Check the hydraulic oil level.<br />
► Check the TV‐belt condition and tighten it.<br />
62 06 Maintenance Rev. 30.1.2013