LM 286 EN 30012013.book - Oy LAIMU Ab

5.11 Maintenance every 1,000 operating hours
User manual LM 286
Also carry out maintenance items 1‐21.
5.11.1 Air conditioning maintenance (accessory) (23)
Check the air conditioning function. When it comes to air conditioning
repairs and fluid filling, contact an authorised service workshop.
The adding of air conditioning coolant/the checking and adding of
lubricant must be done every 3 years in an authorised service workshop.
5.11.2 Hydraulic oil change and tank cleaning (24)
Draining:
► Warm up the hydraulic oil by loading the hydraulics system.
► Lower the front lifter down and turn off the engine.
► Open the plug (A) on the bottom of the tank and drain the old oil into a
container.
Figure 70.
► Install the drain plug (A). If you use Teflon tape for sealing, make sure that
tape pieces are not carried into the tank.
Info!
Ensure that waste oil is disposed of appropriately.
Filling:
► Fill the tank with recommended oil up to the middle of the sight glass
provided in the tank through the filler neck (B) underneath the bonnet.
► Run the engine for a moment while raising and lowering the front lifter, for
example.
► Turn off the engine and recheck the oil level from the sight glass.
► Add oil if necessary.
Info!
See the oil recommendation and volume, 5.6 on page 47.
5.11.3 Fuel tank cleaning (25)
It is recommended always to clean the fuel tank before winter. This
helps to prevent fuel system problems caused by water.
The best way to prevent the formation of condensation water is always
to keep the tank as full as possible, for example, by topping up the tank
at the end of the day.
58 06 Maintenance Rev. 30.1.2013