LM 286 EN 30012013.book - Oy LAIMU Ab
LM 286 EN 30012013.book - Oy LAIMU Ab
LM 286 EN 30012013.book - Oy LAIMU Ab
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
User manual <strong>LM</strong> <strong>286</strong><br />
Provide auxiliary power using starter cables from the battery of another<br />
machine as follows:<br />
1. Drive the auxiliary machine close enough to the multi‐purpose machine to<br />
allow the cables to connect them. THE MACHINES MUST NOT TOUCH EACH<br />
OTHER.<br />
2. Set all controls to neutral on both machines.<br />
3. Use protective glasses and rubber gloves.<br />
4. Use the red starter cable to connect the positive terminals of the auxiliary<br />
battery and the machine battery.<br />
5. Connect the black starter cable to the negative terminal of the auxiliary<br />
battery.<br />
6. Connect the other end of the black cable to the frame of the machine.<br />
7. Start the engine of the machine providing the power, and let it run for 2–5<br />
minutes.<br />
8. Start the engine.<br />
9. Detach the starter cables in reverse order (6, 5, and 4).<br />
4.4 Warm‐up operation<br />
Carry out the following actions after starting the engine, but before<br />
starting work:<br />
1. Let the engine run at increased idle for 2 minutes under normal<br />
temperature, and for about 5 minutes in cold weather (winter conditions).<br />
2. Raise and lower the front lifter a few times in cold weather.<br />
3. Do not drive/operate the machine until it is warm enough, that is, the<br />
engine runs steadily and the hydraulics operate normally.<br />
4.5 Hand throttle<br />
Figure 34.<br />
4.6 Stopping the engine<br />
Adjust the engine revolutions by pressing the button in the middle of the<br />
control (1) and by pulling the control outwards. Fine adjustment is done by<br />
rotating the ring of the control.<br />
4.7 Driving<br />
Huomaa! Notera! Note!<br />
Always lower all tools and apply the parking brake before stopping<br />
the engine.<br />
1. Drive the machine onto hard, level terrain.<br />
2. Lower all tools onto the ground and apply the parking brake.<br />
3. Decrease the engine RPM to idle, and move all controls to neutral or off.<br />
4. Let the engine run at idle for a few minutes to balance the heat and cool it<br />
down.<br />
5. Turn the ignition key to the O position and remove the key.<br />
6. Lock the cabin door before leaving the machine.<br />
The functions related to driving the <strong>LM</strong> <strong>286</strong> multi‐function machine<br />
forwards/backwards are performed with the double action drive pedal.<br />
32 05 Driving and use Rev. 30.1.2013