LM 286 EN 30012013.book - Oy LAIMU Ab

User manual LM 286
3.4 Instrument panel
Figure 16.
1. Tachometer 2. Fuel gauge 3. Engine temperature gauge
4. Parking lights indicator 5. Not used 6. Turn signal indicator
7. Not used 8. High beam indicator 9. Glow indicator
10. Hydraulics return filter
indicator
11. Operating time counter 12. Parking brake indicator
13. Engine overheat warning
light
14. Engine oil pressure warning light 15. Charge indicator
1. The tachometer indicates the engine revolutions as rev/min. The reading is
multiplied by 100, e.g., 35 = 3,500 rev/min.
2. The fuel gauge indicates the fuel amount remaining in the tank. When the
pointer is in the red zone, approximately 7 litres of fuel remain.
3. The engine temperature gauge indicates the temperature of the engine
coolant.
The running temperature is normal when the pointer is in the green
zone. If the pointer is in the red zone, the engine is overheating and
warning light (13) illuminates. Immediately adjust the engine
revolutions to idle and let the engine cool down for a moment. Turn off
the engine and determine the cause of overheating and correct it before
continuing work.
When the pointer is in the blue zone, the running temperature is too
low. Let the engine warm up to the normal (green) running temperature
before heavy loading.
In very cold or hot conditions it may be necessary to change the engine
thermostat to suit the conditions.
4. The parking lights indicator (green) illuminates when the lights are switched
on.
5. Not used
6. The indicator flashes when a turn signal is switched on (left/right).
7. Not used
8. The high beam indicator (blue) illuminates when the beam is switched on.
9. The glow indicator (yellow) illuminates when the engine is preheated and
turns off when the engine is ready to be started.
16 04 Cabin and controls Rev. 30.1.2013