LM 286 EN 30012013.book - Oy LAIMU Ab

More documents

Recommendations

Info

LM 286 User manual 1.3 During maintenance • Park the machine on hard level terrain, lower all tools and stop the engine. • Always keep first aid equipment and a fire extinguisher near the maintenance area. • If you are working underneath a raised bonnet/platform body, support it mechanically in the upper position. • Take into account that there may be residual pressure in the hydraulics system after the engine has stopped. • If you disconnect hydraulic parts, first ensure that the oil has cooled down sufficiently to prevent burns. • Open the connections carefully so that the oil does not discharge forcefully. • Before maintaining the engine, exhaust piping, radiator or hydraulics, let the machine cool down completely. • Always stop the engine before refuelling. Avoid splashing and over filling. • Do not smoke during refuelling and battery maintenance! Ensure that no spark or naked flame gets near the fuel tank or battery. The battery releases flammable gas, especially during charging. • Read “Using auxiliary battery” 4.3.4 p. 31 before using auxiliary batteries in connection with start‐up. • Do not place metal objects on top of the battery terminals. • Prevent short circuits and sparking, always disconnect the negative battery cable first and connect the positive cable first. • Do not open the radiator cap before the liquid has cooled down. Unscrew the cap carefully and let the pressure discharge slowly. Varoitus! Varning! Warning! A needle‐sharp discharging hydraulic oil jet may be invisible and penetrate clothes and skin causing severe damage. 1.4 Labels and plates Never check for leaks with your hands. Use a piece of cardboard instead, for example. Wear a face mask and work gloves. If oil gets under your skin, seek medical attention immediately. Oil may cause necrosis, serious infection and allergic reactions. • The battery and its acid contain heavy metals. Dispose of batteries according to the regulations in effect. • Observe all valid laws and regulations when disposing of oils, antifreeze, solvents, batteries and battery acid. • Wear a face mask and safety goggles to protect your eyes and respiratory organs against dust and other particles. • Never go underneath the machine until you are absolutely sure that it will stay in the raised position. Always use appropriate trestles or other reliable support systems. • Lock the machine's body link with a locking pin or bar before raising the machine with lifting straps (body steered machines), for example. • Do not lift the rolling rear axle from the middle (axle‐equipped machines). • Never go underneath a raised fork unless it is locked in place with a maintenance stand. • Follow all the instructions on the labels attached to the machine. • Keep the labels and plates clean and in readable condition. Rev. 30.1.2013 02 Safety 7
User manual LM 286 Notes: • Clean the labels with soap and water, dry with a soft cloth. • Replace damaged or worn labels with new ones. • If you replace a component that carries a label, ensure that a new label is positioned in the same place. • Stick new labels on a dry, clean and greaseless surface. The minimum temperature requirement is +10 °C. 8 02 Safety Rev. 30.1.2013
Page 2 and 3: LM 286 User manual 1.0 FOREWORD Con
Page 4 and 5: LM 286 User manual 1.1 Machine spec
Page 6 and 7: LM 286 User manual 1.2 User manual
Page 8 and 9: LM 286 User manual 1.0 FOREWORD ...
Page 10 and 11: LM 286 User manual 5.10.2 Drive pum
Page 12 and 13: LM 286 User manual 1.0 SAFETY 1.1 M
Page 16 and 17: LM 286 User manual 2.0 MACHINE STRU
Page 18 and 19: LM 286 User manual 2.1.1 Hydraulic
Page 20 and 21: LM 286 User manual Relief cylinder
Page 22 and 23: LM 286 User manual 3.0 CABIN AND CO
Page 24 and 25: LM 286 User manual Huomaa! Notera!
Page 26 and 27: LM 286 User manual 3.6.1 Side panel
Page 28 and 29: LM 286 User manual High beam indica
Page 30 and 31: LM 286 User manual Heater control T
Page 32 and 33: LM 286 User manual 3.9.3 Emergency
Page 34 and 35: LM 286 User manual 4.0 DRIVING AND
Page 36 and 37: LM 286 User manual 4.2.4 Armrest, m
Page 38 and 39: LM 286 User manual 4.3.2 Starting F
Page 40 and 41: LM 286 User manual 4.7.1 Drive peda
Page 42 and 43: LM 286 User manual 4.8.4 Using the
Page 44 and 45: LM 286 User manual 5.0 MAINTENANCE
Page 46 and 47: LM 286 User manual 5.1.2 Cooling sy
Page 48 and 49: LM 286 User manual 5.2.1 Fuses and
Page 50 and 51: LM 286 User manual 5.3 Headlight ad
Page 52 and 53: LM 286 User manual 5.5 Periodic mai
Page 54 and 55: LM 286 User manual 5.6 Recommended
Page 56 and 57: LM 286 User manual 5.7.4 Air filter
Page 58 and 59: LM 286 User manual 5.7.6 Washer flu
Page 60 and 61: LM 286 User manual 5.8.3 Engine oil
Page 62 and 63: LM 286 User manual 5.9.3 Engine oil
Page 64 and 65:
LM 286 User manual 5.10 Maintenance
Page 66 and 67:
LM 286 User manual Tank cleaning:
Page 68 and 69:
LM 286 User manual 5.12.2 Alternato
Page 70 and 71:
LM 286 User manual ► Start the en
Page 72 and 73:
LM 286 User manual 6.0 TECHNICAL SP
Page 74 and 75:
LM 286 User manual 6.1.11 Electrica
Page 76 and 77:
LM 286 User manual 6.3 Service memo
Page 78 and 79:
LM 286 User manual Hour counter rea
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86:
www.laimu.fi OY LAI-MU AB
show all

LM 286 EN 30012013.book - Oy LAIMU Ab

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?