LM 286 EN 30012013.book - Oy LAIMU Ab
LM 286 EN 30012013.book - Oy LAIMU Ab
LM 286 EN 30012013.book - Oy LAIMU Ab
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>LM</strong> <strong>286</strong><br />
User manual<br />
5.9.3 Engine oil filter replacement (16)<br />
While the oil is draining, change the new oil filter (B):<br />
Figure 63.<br />
► Remove the old filter with a filter wrench.<br />
► Wipe off drained oil and ensure that the sealing face of the filter base is<br />
clean.<br />
► Lubricate the sealing face of the new filter with fresh lubricating oil.<br />
► Rotate the filter into position until the sealing face makes contact and then<br />
tighten by hand by approximately half a turn.<br />
► Start the engine and let it run for a moment. Check that the oil pressure<br />
indicator extinguishes.<br />
► Turn off the engine and check the oil level after a moment using the dipstick.<br />
Add oil if necessary.<br />
5.9.4 Fuel water separator cleaning and fuel filter replacement (17)<br />
Water separator draining:<br />
► Open the drain plug (7) in the bottom of the filter (A) and drain the filter cup.<br />
► Close the drain plug (7).<br />
Figure 64.<br />
Filter replacement:<br />
► Open the fastener (2) on top of the filter. Take hold of the nut (6) below and<br />
remove the old filter.<br />
► Clean all parts carefully before reassembly.<br />
► Install a new filter and seals.<br />
► Bleeding the filter is done using the bleed screw (1) on its cover. Loosen the<br />
bleed screw and run the engine for a moment with the starter until the fuel<br />
coming from the bleed screw stops “bubbling” (no air left in the fuel).<br />
► Retighten the bleed screw.<br />
Rev. 30.1.2013 06 Maintenance 55
Change language