Galileo SOL Manual - Scubapro

2. Menus, settings and functions
To set the altitude, fi rst press ADJ to enter
the ADJUST ALTITUDE menu. Once
inside this menu, use the + or - buttons
until you reach the desired value. Each time
you press + or -, the displayed altitude
will change in 10m/50ft increments. Press
SAVE to confi rm your choice and return to
the main Altimeter menu.
NOTE:
The altitude shown in this menu has
no infl uence on the automatic altitude
adjustment in the decompression
calculations.
2.6 Warning settings
Galileo can warn you about specifi c
situations that might require an action on
your part.
Warnings represent situations that require
the diver’s attention, but ignoring them does
not represent an immediate risk. It is up to
you to decide which ones you would like to
be active and which ones not. All warnings
can be OFF, VISUAL only, AUDIBLE only,
or BOTH visual and audible. The audible
warning consists of three short sequences
of beeps. The visual warning is described
independently for each case.
If a warning is set to VISUAL or BOTH and
it is triggered while Galileo is in compass
mode, the display will automatically switch
back to the regular confi guration (CLASSIC,
LIGHT or FULL) in order to properly show
the warning message.
Each warning has its own submenu within
the Warning settings menu. Use the “”
or “” buttons to scroll through the list.
A highlighted bar will show the selected
submenu and the hint line at the bottom
indicates the status of the warning. Press
ENTR to access any submenu. At any point
in time pressing and holding the right
button will return to the Warning settings
menu without saving any unconfi rmed
changes.
24