Galileo SOL Manual - Scubapro
Galileo SOL Manual - Scubapro
Galileo SOL Manual - Scubapro
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3. Diving with <strong>Galileo</strong><br />
support diving with more than one gas<br />
mixture. If you set the screen confi guration<br />
to LIGHT and then program more than one<br />
gas, <strong>Galileo</strong> will automatically switch to the<br />
CLASSIC lay-out.<br />
NOTE:<br />
Only the shorter between no-stop<br />
time and RBT is shown in LIGHT<br />
confi guration. If your remaining gas<br />
supply is such that you will enter<br />
level stops or deco prior to reaching<br />
an RBT of 0 minutes, the no-stop<br />
time will be displayed on the screen,<br />
emphasized by the NO STOP label. If<br />
on the other hand your remaining gas<br />
supply is such that you will reach RBT<br />
of 0 minutes while still in the no-stop<br />
phase, then the RBT will be displayed<br />
on the screen, emphasized by the<br />
RBT label.<br />
More specifi cally, the following information<br />
is displayed:<br />
- current depth<br />
- dive time<br />
- the shorter between no-stop time and<br />
RBT<br />
- tank pressure<br />
- nitrogen loading (via bar graph)<br />
- buddy tank pressure (only if BUDDY<br />
tank designation has been paired, see<br />
section 1.11)<br />
- (active MB level if different than L0)<br />
- (no-stop information relative to L0 if an<br />
MB level between L1 and L5 is active,<br />
see section 3.5.3)<br />
- time of day<br />
- CNS O 2<br />
Each time you press the button the<br />
information changes to the next one in the<br />
sequence and stays there for 4 seconds<br />
before reverting to the tank pressure. If you<br />
press the MORE button again after the<br />
fi eld has reverted to your tank pressure, the<br />
sequence of additional information will pick<br />
up again from the last displayed data.<br />
3.3.4 FULL screen configuration<br />
WARNING<br />
After a PRESSURE SIGNAL LOST warning,<br />
<strong>Galileo</strong> is not able to compute the RBT any<br />
longer. In such case, the LIGHT configuration<br />
shows the no-stop time but this does not imply<br />
that you have enough gas supply to remain at<br />
that depth for that amount of time.<br />
Upon pressing the middle button (marked<br />
MORE), you can retrieve alternate information.<br />
This information appears instead of the tank<br />
pressure and stays on the display only for<br />
4 seconds, after which the tank pressure<br />
is shown again. The alternate information<br />
appears in the following sequence:<br />
- maximum depth<br />
- O 2%<br />
- temperature<br />
- heart rate<br />
This screen confi guration is meant for<br />
those divers that prefer to have as much<br />
information as possible displayed at once.<br />
More specifi cally, the following information<br />
is displayed:<br />
- current depth<br />
- dive time<br />
- no-stop time (only during no-stop phase<br />
of dive)<br />
- deepest stop, duration of deepest<br />
stop, total ascent time (only during<br />
decompression phase of dive)<br />
- tank pressure<br />
52