Digital Trunking â Desktop/Mobile Radio Scanner - Radio Shack
Digital Trunking â Desktop/Mobile Radio Scanner - Radio Shack
Digital Trunking â Desktop/Mobile Radio Scanner - Radio Shack
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Additional Information<br />
Additional Information<br />
Memory backup<br />
No backup battery required, utilizes non-volatile EEPROM memory.<br />
Power<br />
AC Adapter (Class 2; 12V DC; 600 mA; center tip set to positive).<br />
Specifications are typical; individual units might vary. Specifications and<br />
depictions are subject to change and improvement without notice.<br />
Troubleshooting<br />
Problem Cause Solution<br />
<strong>Scanner</strong> won’t<br />
power on.<br />
The keypad does<br />
not work.<br />
<strong>Scanner</strong> will not<br />
scan when SCAN<br />
is pressed<br />
The scanner does<br />
not receive digital<br />
transmission on<br />
digital frequencies<br />
or trunking<br />
systems.<br />
<strong>Scanner</strong> scans<br />
slowly.<br />
<strong>Scanner</strong> stops on<br />
noise or silence.<br />
The AC adapter or DC<br />
adapter/cable is not<br />
connected.<br />
The scanner may need<br />
to be initialized.<br />
Possible “birdie”<br />
frequency<br />
programmed<br />
The scanner may<br />
need to be reset or<br />
initialized<br />
No channels<br />
programmed, or<br />
only one channel<br />
programmed, or all<br />
channels locked out<br />
SQUELCH control is<br />
not adjusted properly<br />
The digital channel<br />
or talkgroup is not<br />
using APCO-25 digital<br />
modulation.<br />
The digital channel or<br />
talkgroup is encrypted.<br />
The digital channel<br />
or talkgroup is being<br />
transmitted from a<br />
distant location.<br />
SQUELCH control is<br />
set too high.<br />
Subaudible squelch<br />
mode not set.<br />
Be sure the adapter’s barrel plug is<br />
fully plugged into the DC 13.8V jack.<br />
Follow steps in “Initializing the<br />
<strong>Scanner</strong> to Factory Defaults” below.<br />
Tighten squelch, apply attenuator or<br />
lock out the “birdie” frequency<br />
Follow steps in “Initializing the<br />
<strong>Scanner</strong> to Factory Defaults” below.<br />
Ensure that the scanner has more<br />
than one channel programmed and<br />
enabled for scanning<br />
Turn SQUELCH control clockwise<br />
until scanning resumes<br />
The scanner can only receive<br />
APCO-25 C4FM/CQPSK IMBE digital<br />
signals.<br />
The scanner will not receive<br />
encrypted traffic.<br />
Reposition the scanner or use<br />
an outdoor antenna to improve<br />
reception.<br />
Turn SQUELCH control counter<br />
clockwise.<br />
Set the correct subaudible squelch<br />
mode. See “Appendix B: Detailed Menu<br />
Reference: Conv Menu” on page 101.<br />
88<br />
89