V92TC V92TC DELUXE - Polaris
V92TC V92TC DELUXE - Polaris
V92TC V92TC DELUXE - Polaris
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Pre -Operation Check<br />
Engine Stop/Run Switch<br />
Be sure the engine stop/run switch stops the engine, or prevents the engine from starting when set to the Stop<br />
position.<br />
Notice If you regularly use this switch to shut off the engine, you are already checking its operation each<br />
time you use the motorcycle.<br />
Check Engine Oil Level<br />
A dipstick attached to the oil fill cap registers the engine oil<br />
level.<br />
1<br />
1. With the transmission in neutral, start and run the<br />
engine for several minutes.<br />
2. Shut the engine off and wait for 3 -5 minutes.<br />
3. Straddle the motorcycle on level ground and bring it to<br />
a vertical position. Remove the oil fill cap and wipe the<br />
dipstick clean. Reinstall the dipstick and turn the cap<br />
1. Oil Fill Cap/Dipstick<br />
clockwise until it seats.<br />
4. Remove the dipstick again and note the oil level.<br />
1 2<br />
5. If necessary, add or remove oil to bring the level into<br />
the area on the dipstick above the ADD mark and<br />
below the FULL mark (see “Engine Oil<br />
Specifications,” page 139). Repeat steps 1 -2 each time<br />
you adjust the oil level.<br />
1. ADD Mark 2. FULL Mark<br />
47
Change language