USER'S MANUAL Ladder Editor 32 version 1.2 - Motoman

MOTOMAN ROBOTICS EUROPE
User’s manual Ladder Editor 32 Page: 39
Inserting editing matrix row and line
Created: 96-01-31 Revised: 01-04-05 Doc. name: Mrs55130-ch10.fm
■ Setting names using a pop-up menu
Names can be also set in the following manner using the pop-up menu.
How to operate
1) Select the ladder parts where the relay No. or register No. of the name to be
edited is set.
Right-click the mouse on the ladder parts where the relay No. or register No.
of the name to be edited is set in the "ladder editing" display, and the pop-up
menu appears. Select the [Input Name], the [Input name] dialog box appears.
2) Edit the name.
Edit the displayed name for a relay No. or register No. in the [Input name] dialog
box.
10.8 Inserting editing matrix row and line
Even though new ladder parts are to be inserted immediately before the ladder
parts that have already been set, there may be no matrix for insertion as shown in
the following diagram.
In this case, insert a line (or a row) to secure the matrix where the ladder parts are
to be inserted.
10.8.A Inserting a row
Insert a row in the following manner.
How to operate
1) Enter the row insertion mode.
Select [Tool] – [Mode] – [Row control] – [Insert Row].
Or select
Fig.31 When no space for matrix
from the parts control tool bar (refer to "Parts Control Tool Bar").
2) Specify the matrix where a row is to be inserted.
Left-click the mouse on the matrix where a row is to be inserted.
Fig.32 Result of Row Insertion