USER'S MANUAL Ladder Editor 32 version 1.2 - Motoman

MOTOMAN ROBOTICS EUROPE
User’s manual Ladder Editor 32 Page: 83
Automatic work storing function
Created: 96-01-31 Revised: 01-04-09 Doc. name: Mrs55130-ch24.fm
24.4 Automatic work storing function
If any interference occurs at editing and the application shuts down before storing
the editing data, Ladder Editor 32 has a function to create a work file (data file
being edited) automatically.
How to operate
1) Refer to “Other optional settings”.
2) With this function, the data in its current state is stored in a work file when a
line is changed, inserted, or deleted in the "ladder editing" display. The stored
file is saved with the following file name in the same folder as the ladder program
file or CMOS file that is being edited.
Opened file name + “.TMP”
Note!
Even if a CMOS.HEX file is read and edited, the work file is output as
a ladder file (text file).
Note!
The data that is being edited in the "ladder editing" display is
not stored.
24.5 Automatic Backup Function of the Read-in File (Original File)
When storing edited data, Ladder Editor 32 has a function to automatically back
up the files before editing.
How to Operate
Refer to “Other Optional Settings”.
The automatic backup function is available for the following files:
✔ Ladder files (*.LST)
✔ CMOS files (*.HEX)
✔ Name files (*.NAM)
A file name of one of these backup files has an “_” (under score) after each file
extension in the same folder as the original files:
Relevant file name + extension + “_”