Responder LE Model 5701 Security and Remote Start Installation ...

H2/6 LIGHT BLUE (-) 200mA 2nd unlock output
This wire produces a (-) 200mA output for progressive locks in which the driver
door unlocks first and the remaining locks will unlock with a second press of the
unlock button on the remote.
Note: This feature will need to be programmed “On” to function correctly (see
System Feature Menu #1, feature 8)
H2/7 GRAY/BLACK (-) Diesel wait-to-start input
Connect this wire to the wire in the vehicle that sends the signal to turn on
the WAIT-TO-START bulb in the dashboard. In most diesels the wire is negative
(ground turns on the bulb) and the GRAY/BLACK wire can be directly connected
to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the
bulb) a relay must be used to change the polarity.
Note: The system has a programmable onboard timer (See Feature menu#3, feature
9) so it is not mandatory to connect to the wait-to-start wire in the vehicle.
Note: A 1-amp diode must be installed in line on the factory wire between the
wait-to-start indicator and the ECM. (See the following diagram for details.)
32
© 2008 Directed Electronics—all rights reserved