Responder LE Model 5701 Security and Remote Start Installation ...

More documents

Recommendations

Info

Warning! Safety first The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed Electronics dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control Therefore, never operate the system in an area that does not have adequate ventilation. The following precautions are the sole responsibility of the user; however, authorized Directed Electronics dealers should make the following recommendations to all users of this system: 1. Never operate the system in an enclosed or partially enclosed area without ventilation (such as a garage). 2. When parking in an enclosed or partially enclosed area or when having the vehicle serviced, the remote start system must be disabled using the installed toggle switch. 3. It is the user's sole responsibility to properly handle and keep out of reach from children all remote controls to assure that the system does not unintentionally remote start the vehicle. 4. USER MUST INSTALL A CARBON MONOXIDE DETECTOR IN OR ABOUT THE LIVING AREA ADJACENT TO THE VEHICLE. ALL DOORS LEADING FROM ADJACENT LIVING AREAS TO THE ENCLOSED OR PARTIALLY ENCLOSED VEHICLE STORAGE AREA MUST REMAIN CLOSED AT ALL TIMES. • Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal injury, or death. Except when performing the Safety Check outlined in this installation guide, (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the keys in the ignition. The user will be responsible for having the neutral safety feature of the vehicle periodically checked, wherein the vehicle must not remotely start while the car is in gear. This testing should be performed by an authorized Directed Electronics dealer in accordance with the Safety Check outlined in this product installation guide. If the vehicle starts in gear, cease remote start operation immediately and consult with the user to fix the problem immediately. © 2008 Directed Electronics—all rights reserved
• After the remote start module has been installed, test the remote start module in accordance with the Safety Check outlined in this installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed. The remote start module must be removed or properly reinstalled so that the vehicle does not start in gear. All installations must be performed by an authorized Directed Electronics dealer. OPERATION OF THE REMOTE START MODULE IF THE VEHICLE STARTS IN GEAR IS CONTRARY TO ITS INTENDED MODE OF OPERATION. OPERATING THE REMOTE START SYSTEM UNDER THESE CONDITIONS MAY RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY. IMMEDIATELY CEASE THE USE OF THE UNIT AND REPAIR OR DISCONNECT THE INSTALLED REMOTE START MODULE. DIRECTED ELECTRONICS, INC. WILL NOT BE HELD RESPONSIBLE OR PAY FOR INSTALLATION OR REINSTALLATION COSTS. • Remote starters for manual transmission pose significant risks if not properly installed and operated. When testing to ensure the installation is working properly, only remote start the vehicle in neutral gear, on a flat surface and with a functional, fully engaged parking brake. Do not allow anyone to stand in front of or behind the vehicle. • This product should NOT be installed in any convertible vehicles, soft or hard top. Installation in such vehicles may pose certain risk. © 2008 Directed Electronics—all rights reserved
Page 1 and 2: Responder LE Model 5701 Security an
Page 3 and 4: Table of contents What is included
Page 5: What is included • The control mo
Page 9 and 10: After the installation • Test all
Page 11 and 12: Control module Some things to remem
Page 13 and 14: Finding the wires you need Now that
Page 15 and 16: Starter wire The starter wire provi
Page 17 and 18: Wait-to-start bulb wire for diesels
Page 19 and 20: Door pin switch circuit The best pl
Page 21 and 22: Primary harness (H1), 12-pin connec
Page 23 and 24: Remote start auxiliary output, 5-pi
Page 25 and 26: H1/3 BROWN (+) Siren output Connect
Page 27 and 28: H1/6 VIOLET (+) Door trigger input,
Page 29 and 30: H1/11 WHITE Parking light output Th
Page 31 and 32: H2/4 VIOLET/BLACK 200 mA (-) progra
Page 33 and 34: (+)WAIT-TO-START WIRE H2/8 BROWN/BL
Page 35 and 36: Type A: Three-wire (+) pulse contro
Page 37 and 38: Type C: Direct-wired reversing pola
Page 39 and 40: Type E: Electrically-activated vacu
Page 41 and 42: Type G: Positive (+) multiplex The
Page 43 and 44: Determining the Proper Resistor Val
Page 45 and 46: H3/8 PINK/BLACK - 87a of Ignition 2
Page 47 and 48: Outputs for optional ext. remote st
Page 49 and 50: Testing the neutral safety switch 1
Page 51 and 52: Plug-in LED and valet/program switc
Page 53 and 54: Tach learning To learn the tach sig
Page 55 and 56: Setting the light flash polarity Li
Page 57 and 58:
3. Choose. Within 10 seconds, press
Page 59 and 60:
The remote control buttons that ope
Page 61 and 62:
4. Select a Feature. Press and rele
Page 63 and 64:
Feature menus Menu 1 - Security fea
Page 65 and 66:
Menu 3 - Remote start features Menu
Page 67 and 68:
1-5 IGNITION LOCKS OFF : (1) When t
Page 69 and 70:
Menu 2 - Convenience features Defau
Page 71 and 72:
2-10 Channel 1 Linking, None (1) Ar
Page 73 and 74:
To activate manually a push button
Page 75 and 76:
Bitwriter® features The Bitwriter
Page 77 and 78:
Valet mode To enter or exit valet m
Page 79 and 80:
Timer Mode This unit can be program
Page 81 and 82:
Table of zones When using the Diagn
Page 83 and 84:
Remote starting diagnostics When th
Page 85 and 86:
Troubleshooting Alarm • Shock sen
Page 87 and 88:
6. Check connections. The heavy gau
Page 89 and 90:
Responder LE Quick Reference Wiring
show all

Responder LE Model 5701 Security and Remote Start Installation ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?