Responder LE Model 5701 Security and Remote Start Installation ...

Outputs for optional ext. remote start relays
These signals are provided to drive additonal optional relays.
PINK/WHITE (-) 200mA Flex Relay Control Output
This wire is programmed as (-) 2nd ignition output from factory and can be programmed
(to drive a relay) as a (-) starter or accessory output.
ORANGE (-) 200mA Accessory output
This wire works like the main accessory wire and can be used (with a relay) to
drive any additional accessory circuits in the vehicle.
VIOLET (-) 200mA Starter output
This wire works like the starter wire and can be used (with a relay) to drive any
additional starter circuits in the vehicle.
PINK (-) 200mA ignition 1 output
This wire works like the ignition 1 wire and can be used (with a relay) to drive
any additional ignition circuits in the vehicle.
Note: Wires 1 - 4 on the remote start auxiliary outputs are wired to the (-)
triggers for the onboard remote start relays and are not diode isolated. If wiring
these wires directly to the vehicle you must place a 1-amp diode in line to
prevent feedback from the vehicle.
BLUE (-) 200mA status output
This wire supplies an output as soon as the module begins the remote start process.
It can be used to activate a bypass module or power the key sense wire in
most vehicles to disarm the factory alarm without unlocking.
Note: Check vehicle information to verify if a bypass module is needed or if the
key sense wire is needed.
© 2008 Directed Electronics—all rights reserved 47