Responder LE Model 5701 Security and Remote Start Installation ...

Feature descriptions
The features of the system are described below. Features that have additional
settings that can be selected only when programming with the Bitwriter® are
indicated by the following icon:
Menu 1 - Security features
Default settings are in bold.
Note: The numbers in parentheses indicate the number of times the LED on the
antenna will flash.
1-1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will
only arm when the transmitter is used. When set to passive the system will arm
automatically 30 seconds after the last door is closed. To alert the consumer
of passive arming, the siren will chirp 20 seconds after the door is closed. This
provides the consumer with an audible warning prior to the system actually arming.
At the 30 second mark the system will arm but the siren will not chirp.
1-2 PANIC ON: (1 LED flash) This feature controls whether or not the panic mode
is available with the ignition on. In some states there are laws prohibiting a
siren sounding in a moving vehicle. This feature makes the system compliant with
these regulations. The LED flashes twice (2) to indicate Panic with ignition OFF.
When Panic is OFF, the LED flashes (3)
1-3 Arm/disarm and Warn Away CHIRPS ON: (1) This feature controls the chirps
that confirm the arming and disarming of the system, Arm/Disarm chirps ON,
w/Warn Away chirps OFF (2), Arm/disarm chirps OFF, w/ Warn Away chirps ON (3),
Arm/disarm chirps OFF, w/Warn Away chirps OFF (4).
1-4 30 SEC SIREN DURATION: It is possible to program the unit to sound for
30 or 60 seconds during the triggered sequence. Some states have laws regulating
how long a security system can sound.
When using the Bitwriter®, the siren can be programmed to sound for any length
of time from 1 second to 180 seconds.
66
© 2008 Directed Electronics—all rights reserved