Responder LE Model 5701 Security and Remote Start Installation ...

To activate manually a push button needs to be hardwired to the (-) activation
input on the remote start unit. When the vehicle is running press the button the
appropriate amount of times to activate the remote start (factory setting is for 1
pulse). The remote emits a confirmation tone. You can then turn off the ignition
and the car will stay running for the pre programmed amount of time.
Note: For this feature to work the “turbo timer run time” mode needs to be programmed
ON and the tachometer wire on the remote start needs to be connected
and programmed.
3-7 TIMER MODE RUN TIME—12min (1), This is the default setting. Selects
the time in minutes that the system will operate the engine until the system
"times out" when the remote start activates in timer mode. Use the two-chirp
setting for 3(2), 6 (3), 9 (4) MINUTES: This is the maximum operation period and
the system may be shut down using a shutdown at any time. Using the Bitwriter®,
the run time can be programmed for any duration from 1-16 minutes.
Note: The numbers in parentheses indicate the number of times the LED will
flash.
3-8 FLEX RELAY FUNCTION: Ignition 2 (1) In the factory setting, the flex relay
will function the same as the pink ignition 1 wire, in accessory setting the flex
relay will function the same as the Orange accessory 1 wire, in starter setting the
flex relay will function the same as the purple starter 1 wire.
3-9 DIESEL TIMER—WAIT-TO-START INPUT - Timed 15, 30, 45 SECONDS:
Default is the “Wait-to-Start” input control wire, or programmable to ignore the
input control wire by a delay of 15 (2), 30 (3), or 45(3) seconds. This feature can
also be optionally programmed with the Bitwriter®, with a delay from 1 to 90
seconds.
Note: The numbers in parentheses indicate the number of times the LED will
flash.
3-10 ACCESSORY STATE DURING WAIT-TO-START ON: This feature will allow the
selection of the accessory output to be ON or OFF during wait-to-start. Use the
two-chirp setting for OFF.
© 2008 Directed Electronics—all rights reserved 73