Installation and Operating Instructions - Crompton Instruments

PROTECTIVE FUNCTION DETAIL
The Relay Protective Trip Functions are detailed in Table 1 (shown again here for convenience).
Table 1 Relay Protective Trip Functions
ANSI Type No Menu Description Description
Unused
The relay is disabled
59 Over Volts Over Voltage Relay
27 Under Volts Under Voltage Relay
81O Over Freq Over Frequency Relay
81U Under Freq Under Frequency Relay
50 Over Amps Instantaneous Over Current Relay
37 Under Amps Instantaneous Under Current Relay
50N Over Amps Instantaneous Over Neutral Current Relay
32R Reverse Pwr Reverse Power Relay
32O Over Power Forward Power Relay
40Q Reverse VAr Reverse VAr Relay
47 UnBal Volts Unbalanced Voltage Relay
46 UnBal Amps Unbalanced Current Relay
51V I/T+V.R. Time Over Current with Voltage Restraint Relay
51 I/T Time Over Current Relay
51G Gnd Fault Neutral Ground Fault Relay
25 Sync Synchronism Check Relay
25D Sync+DB Synchronism Check with Dead Bus Relay
47 Phase Order Phase Sequence Relay
Logical AND
Logical OR
Logical NAND
Logical NOR
Logical XOR
Logical Vote
Logical Disc
Alarm
Unack Alarm
Will trip if all 3 inputs are tripped
Will trip if any input is tripped
Will trip unless all 3 inputs are tripped
Will trip if any input is not tripped
Will trip if the 3 inputs are not in the same state
Will trip if at least 2 inputs are tripped
Will trip if there is a discrepancy between inputs
Will trip if an alarm situation exists
Will trip if an alarm has not been acknowledged
Accuracy levels and resolution of trip settings are detailed in ACCURACY AND RESOLUTION
(located in the product specification section) unless otherwise stated.
51