MW810 Mobile Workstation User Guide - Motorola Solutions

Mode LED
The Mode LED inside the Power Button indicates the following
status:
• Steady green: Workstation is on, vehicle power is ok and
video signals are received from CPU Box.
• Steady yellow: Workstation is in Sleep state or no input
video signals are received from the CPU Box.
NOTE: During Sleep state, the workstation enters a powersaving
mode, the display back-light turns off and the workstation
speed slows down. The workstation radios remain
powered on.
To resume from Sleep state, press any control button, touch
screen, keyboard or touchpad. The workstation returns to the
initial state that existed prior to the Sleep state (previous
screen display, indications, etc.)
2 Touch Screen
SVGA, 800x600 pixels touch screen with analog RGB or DVI
video input. The screen is illuminated by 800 NIT (800 cd/m2
typical) high brightness LED backlighting.
The touch screen (8 wire resistive), can be accurately activated
with either a bare or glove-clad finger or a stylus pen.
The screen is made of tempered glass and is covered by a
protective film to contain shattered glass in the event of
breakage.
3 Emergency Button
Press the illuminated amber Emergency button to send an
emergency message to a dispatcher or any host computer via
the user's 2-way radio system. The Emergency button is functional
as soon as the OS starts to boot up. The button illumination
dims during Sleep state.
In order for this feature to be operational, your
! system administrator must pre-program a
Caution subscriber software application to listen and act
upon this emergency signal.
21