MW810 Mobile Workstation User Guide - Motorola Solutions
MW810 Mobile Workstation User Guide - Motorola Solutions
MW810 Mobile Workstation User Guide - Motorola Solutions
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
8.4" Display - Backpanel Components<br />
Figure 10 shows the backpanel components of the 8.4” Display.<br />
(for installation instructions, refer to <strong>MW810</strong> <strong>Mobile</strong><br />
<strong>Workstation</strong>, Vehicle Installation Manual P/N 6802988C56).<br />
Cable Clamp<br />
Screw Holes<br />
Mounting Screw<br />
Holes (x4) 6<br />
5<br />
1<br />
USB Port 1<br />
4<br />
Power Inlet<br />
1 USB Port<br />
USB 2.0 port for temporary connection of external USB<br />
devices with up to 500mA current load.<br />
!<br />
Caution<br />
24<br />
USB Port<br />
2<br />
3<br />
CPU-to-Display Cable Receptacle<br />
Figure 10. 8.4" Display - Backpanel Components<br />
Do not use USB for permanent connections. Always<br />
remove USB accessories from these ports when<br />
driving. Propelled device can cause serious injury.<br />
Keep the USB ports of the display unit sealed by using the<br />
rubber plugs attached to the display.<br />
3 Keyboard USB Port<br />
USB 2.0 port used to connect the <strong>MW810</strong> <strong>Mobile</strong> <strong>Workstation</strong><br />
keyboard with up to 500mA current load. The Keyboard<br />
USB Port has two threaded bosses for securing the USB connector<br />
of the keyboard to the display.<br />
3 CPU-to-Display Cable Receptacle<br />
Signal cable 50 pin receptacle for connecting the display to<br />
the CPU Box.