PMS 4500 FCB Manual - Ysebaert

Mode of Operation of the Generator
A.4 Operation of the generator with HTG generator
A.4.1 General references
Beside the alternating current aggregates ICEMASTER supplies also the super-compact High
tech battery load aggregates from the series of PANDA AGT in sound-insulated construction,
which represent a very interesting alternative solution in a DC-AC power technology merged for
generation of current within the mobile range. The new HTG generators with 280 A charging current
offer themselves a alternative for an onboard current generator, if a diesel set is not intended.
These generators differ according to the technology very substantially from all conventional
products. The size is so compact that you can exchange it also against a generator according to
standard. This generator can ensure a 230V alternating current supply up to 3.000W power in
connection with a PANDA HD inverter also in continuous operation.
A.5 Operation of generator with installation under the waterline
If the generator cannot be installed clearly at least 600mm over the waterline, a ventilation valve
must be installed into the raw water line. At installation beside the "midship´s line" a possible heeling
must be considered!
The water hose in the sound cover is split on the pressure side of the pump and extended in each
case in the sound cover at both ends with a connecting nipple by a hose end. Both hose ends
must led out from the sound cover to a point, which is at least for 600mm over the waterline (if
possible in the midship´s line). The valve is inserted at the highest place, at least 600mm over the
waterline.
15.7.05 PMS_4500_FCB_manual.V02 - Chapter A: Mode of Operation of the Generator Page 9