Blackfly - CYLOD

Point Grey Blackfly Technical Reference
Appendix A: GenICam Features
A.5 Digital Input Output Control
Name Display Name Description Value
LineSelector
LineMode
LineSource
LineInverter
+ Line Selector
Line Mode
Line Source
Line Inverter
Selects the physical line (or GPIO pin)
of the external device connector to
configure.
Controls whether the physical line is
used to Input or Output a signal.
Choices are dependent on which line is
selected.
Selects which input or output signal to
output on the selected line. Line Mode
must be Output.
Controls the invertion of the signal of
the selected input or output line
StrobeEnabled Strobe Enabled Enables/disables strobe
UserOutputValue
LineStatus
LineStatusAll
User Output Value
Line Status
Line Status All
A.6 Transport Layer Control
All GigE Vision features start with GEV.
PayloadSize
Sets the value of the user output
selector
Returns the current status of the
selected input or output line
Returns the current status of all
available line signals at time of polling
in a single bitfield
Line 0
Line 1
Line 2
Line 3
Input
Trigger
Strobe
Output
Exposure Active
External Trigger Active
True
False
True
False
True = High
False = Low
True = High
False = Low
Name Display Name Description Value
Payload Size
Provides the number of bytes
transferred for each image or chunk
on the stream channel.
This is mainly used by the
application software to determine
size of image buffers to allocate.
GevVersionMajor GEV Version Major Major version of the specification
GevVersionMinor GEV Version Minor Minor version of the specification
GevDeviceModeIsBigEndian
GevDeviceModeCharacterSet
GEV Device Mode Is Big
Endian
GEV Device Mode
Character Set
Endianess of device registers
Character set used by all the strings
of the bootstrap registers
True
False
Revised 12/13/2012
Copyright ©2012 Point Grey Research Inc.
69