MC75 AT Command Set

MC75 AT Command Set
10.1 AT^SICS
s
Write Command (Continued)
AT^SICS=, ,
Response(s)
ERROR
+CME ERROR:
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge Last
! % % % % % % ! % !
Parameter Description
(num)
Internet connection profile identifier.
The identifies all parameters of a connection profile, and, when a service profile is created
with AT^SISS the needs to be set as "conId" value of the AT^SISS parameter .
0...5
(str)
Internet connection parameter.
“conType“
“alphabet“
“user“
“passwd“
“apn“
Type of Internet connection.
For supported values of refer to .
Selects the character set for input and output of string parameters within a profile.
The selected value is bound to the specific profile. This means that different
profiles may use different alphabets. Unlike other parameters the alphabet can
be changed no matter whether the value "conType" has been
set.
For supported values of refer to .
User name string: maximum 32 characters (where "" is default).
Password string: maximum 32 characters (where "" is default).
If is "MsChapV1" then the maximum password
length is 16 characters.
Access point name string value: maximum 100 characters (where "" is default).
“inactTO“ Inactivity timeout value in seconds: 0
Changing the value is not allowed (if changed the value will be reset to 0).
“calledNum“
Called BCD number.
“dataRate“
Data rate.
For supported values of refer to .
“dataType“
Data call type.
For supported values of refer to .
“authMode“
Authentication mode.
For supported values of refer to .
“dns1“
Primary DNS server address (IP address in dotted-four-byte format).
This value determines whether to use the DNS server addresses dynamically
assigned by the network or a specific DNS server address given by the user.
"dns1" = "0.0.0.0" (default) means that the CSD or GPRS connection profile
MC75_ATC_V01.001 Page 232 of 475 6/2/05
Confidential / Released