MC75 AT Command Set

MC75 AT Command Set
11.11 AT+CGQREQ
s
11.11 AT+CGQREQ Quality of Service Profile (Requested)
Syntax
Test Command
AT+CGQREQ=?
Response(s)
+CGQREQ: , (list of supported s), (list of supported s), (list of
supported s), (list of supported s), (list of supported s)
OK
Read Command
AT+CGQREQ?
Response(s)
[+CGQREQ: , , , , , ]
[+CGQREQ: ...]
Write Command
AT+CGQREQ=[[, [, [, [, [, ]]]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge Last
GSM 07.07 % % % % % % % ! % !
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context.
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an Activate
PDP Context Request message to the network.
The set command specifies a profile for the context identified by the (local) context identification parameter,
.
A special form of the set command, +CGQREQ= causes the requested profile for context number
to become undefined.
AT&F and ATZ will undefine the QoS profiles of every context which is not active or not online.
Parameter Description
(num)
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
(num)
Precedence class
[0] network subscribed value
1 High Priority
Service commitments shall be maintained ahead of precedence classes 2 and
3
MC75_ATC_V01.001 Page 287 of 475 6/2/05
Confidential / Released