Untitled - Innova

Using the Scan Tool
VIEWING ENHANCED DTCs
- Press the ENTER button to return to the Ford/Mazda
Enhanced menu.
2. An “instructional” message shows on the Scan Tool’s display.
Perform test procedures as appropriate.
• If the Continuous Memory or KOEO
test was selected, turn the ignition
OFF, then back ON. Press the
ENTER button to start the test.
- A “One moment please” message
displays while the test is in
progress.
• If the KOER test was selected,
press the ENTER button to
continue.
- A “One moment please” message
displays while the test is in
progress.
- Turn the steering wheel to the
right, then release.
- Press and release the brake pedal.
- Cycle the overdrive switch (if equipped).
3. To read the display:
Refer to DISPLAY FUNCTIONS on page 8 for a description of
LCD display elements.
• A visible icon indicates that the Scan Tool is being powered
through the vehicle’s DLC connector.
• The upper right hand corner of the
display shows the number of the
code currently being displayed, the
total number of codes retrieved.
• The Diagnostic Trouble Code (DTC)
and related code definition are
shown in the lower section of the
LCD display.
I/M MONITOR STATUS icons are not displayed when
viewing enhanced DTCs.
In the case of long code definitions, or when viewing
Freeze Frame data, a small arrow is shown in the
upper/lower right-hand corner of the code display area
to indicate the presence of additional information. Use
the and buttons, as necessary, to view the
additional information.
OBD2 43