Untitled - Innova

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
9. You can exit the "Record Live Data Mode" at any time by pressing
and holding the LD/M button until the "Mode Selection Menu"
displays.
If desired, you can transfer the recorded Live Data information
to a personal computer with the use of optional software (see
instructions included with the software for more information).
Record by Manual Trigger
This option lets you select the precise time at which the Live Data
recording will occur. Record by Manual Trigger can be a very valuable
diagnostic tool when troubleshooting intermittent problems that do not
meet the requirements for a DTC to set. Even though a DTC is not
present, the intermittent problems will sometimes manifest themselves
briefly, for a few fractions of a second and/or only at certain vehicle
speeds or vehicle operating conditions.
1. While linked to the vehicle, start the
engine, then press and release the
LD/M button.
• The “Mode Selection Menu” displays.
2. Use the UP and DOWN buttons,
as necessary, to highlight Live Data,
then press the ENTER
button.
• The “Live Data” menu displays.
3. Use the UP and DOWN buttons,
as necessary, to highlight “Record Live
Data”, then press the ENTER button.
• The "Record Live Data Menu" displays.
4. Use the UP and DOWN buttons,
as necessary, to highlight “Record by
manual trigger”, then press the ENTER
button.
5. When the "Record by Manual Trigger"
screen displays, select the desired
trigger point as follows:
The Scan Tool is capable of recording approximately 100
frames of Live Data. Record by DTC trigger lets you select the
point in time at which you wish the Scan Tool to begin
recording Live Data. You can set the trigger point to record the
100 frames of data before an event (when the DTC was set),
after the event, or in the middle (50 frames before and 50
frames after the event.
66 OBD2