Untitled - Innova

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
• Beginning - records approximately
100 frames of Live Data after the
ENTER button was pressed.
• Middle - records approximately 50
frames of Live Data before and 50
frames after the ENTER button
was pressed.
• End - records approximately 100 frames of Live Data before the
ENTER button was pressed.
6. Use the UP and DOWN buttons, as necessary, to select the
desired trigger point, then press the ENTER button.
• A "One moment please. . ."
message shows on the display.
When the Scan Tool is ready to
record Live Data, the "Record Live
Data" screen displays.
7. Put the engine in the operating condition
where the problem manifests itself.
• If necessary, drive the vehicle until you reach the vehicle speed
at which the problem occurs.
8. When the problem occurs, press and
release the ENTER button.
• All three LEDs will blink for three
seconds to indicate that Live Data is
being recorded, and a "One moment
please. . ." message shows on the
display, along with the number of
the frame being recorded.
• When recording is complete, a
confirmation screen displays, asking
if you would like to view the
recorded data. Use the UP and
DOWN buttons, as necessary, to
select Yes or No, as desired, then
press the ENTER button.
If Yes is selected, the Scan Tool enters "Playback" mode from
which you can view a frame-by-frame playback of recorded Live
Data (see LIVE DATA PLAYBACK on page 68 for details). If No
is selected, the display returns to the "Mode Selection Menu".
9. You can exit the "Record Live Data Mode" at any time by pressing and
holding the LD/M button until the "System Test Menu" displays.
If desired, you can transfer the recorded Live Data information
to a personal computer with the use of optional software (see
instructions included with the software for more information).
OBD2 67