Untitled - Innova

Additional Tests
ADJUSTMENTS AND SETTINGS
• The selected character displays “solid”, and the next character is
highlighted.
3. Select the remaining characters in the DTC in the same way,
pressing the DTC/FF button to confirm each character. When
you have selected all the DTC characters, press the ENTER
button to view the DTC definition.
• If you entered a “Generic” DTC
(DTCs that start with “P0”, “P2” and
some “P3”):
- The selected DTC and DTC
definition (if available) show on
the Scan Tool’s display.
If a definition for the DTC you
entered is not available, an advisory
message shows on the Scan Tool’s
display.
• If you entered a “Manufacturer-Specific” DTC (DTCs that start
with “P1” and some “P3”):
- The “Select Manufacturer” screen
displays.
- Use the UP and DOWN
buttons, as necessary, to highlight
the appropriate manufacturer,
then press the ENTER button
to display the correct DTC for
your vehicle.
If a definition for the DTC you
entered is not available, an
advisory message shows on the
Scan Tool’s display.
4. If you wish to view definitions for
additional DTCs, press the ENTER
button to return to the Enter DTC screen,
and repeat steps 2 and 3.
5. When all desired DTCs have been viewed, press the LD/M
button to exit the DTC Library.
Viewing the Firmware Version
1. Use the UP and DOWN buttons,
as necessary, to highlight Firmware
Version in the Menu, then press the
ENTER button.
OBD2 79