mitsubishi - Al Kossow's Bitsavers

MITSUBISHI MICROCOMPUTERSMELPS 8-48 MASK ROMORDERING METHODMELPS8-48 MASK-PROGRAMMABLE ROM CONFIRMATION MATERIALSINGLE-CHIP 8-BIT MICROCOMPUTERS M5L8048-XXXP, M5L8049-XXXP, P-8, P-6, M5L8049H-XXXP, M5M8050H-XXXP,M5M8050L-XXXP, M5M80C49-XXXPMITSUBISHI ELECTRICSignatureCustomerCompany namePreparedCompany addressTelCompany contactDateApprovedThe single-chip microcomputer type number to order andthe type of EPROMs to be supplied should be specified bychecking \lin the boxes. Three sets of EPROMs should besupplied.~ermicrocomputer type number02716 02732OM5L8048-XXXP OA (00016 - 3FF16) OA (00016 - 3FF16) 08748OM5L8049-XXXPOM5L8049-XXXP-8 OA (00016 - 7FF16) OA (00016 - 7FF16) 08749OM5L8049-XXXP-6OM5L8049H-XXXP OA (00016 - 7FF16) OA (00016 - 7FF16) 08749OM5M8050H-XXXP OA (00016 - 7FF16)OM5M8050L-XXXP DB (80016 - FFF16)OA (00016 -FFF16)-Notel: The high-level data of both data outputs and address inputs of the supplied EPROM will be programmed as '1', andlOW-level as '0'.2 : Cleary indicate the type number of EPROMs and address designation letter symbols A and B on the suppliedEPROMs.3 : The data of the addresses in parentheses on the EPROM are programmed onto the ROM.4 : The data from each PROM in the set is compared and if 2 of the 3 are equal, the equal value will be programmedinto the·ROM. When the 3 values are different programming is halted and the customer is notified of the error. Theerror report will show the address and data.CUSTOMER'S IDENTIFICATION MARKIf you require a special identification mark, please specify in the following format.Mitsubishi IC type numberNote 5 : A mark field should start with the box at the extreme right.6 : The identification mard should be no more than 12 characters consisting of alphanumericcharacters (except J.1. and 0) or dashes.COMMENTS8-8.• MITSUBISHI..... ELECTRIC