Operator's Manual-AVEA - Static Content
Operator's Manual-AVEA - Static Content
Operator's Manual-AVEA - Static Content
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
86 Bear Cub 750PSV<br />
Display PCB Removal<br />
1. Remove control PCB . See Control PCB Removal Figure 8-5.<br />
2. Remove five screws shown in Figure 8-6.<br />
3. Disconnect ground wire.<br />
4. Remove board from unit.<br />
5. To install, reverse removal procedure.<br />
Air/O2 Regulator Removal<br />
1. Remove Air/O2 fittings from the rear of the ventilator. See Figure 8-7.<br />
2. Remove all hoses necessary to free the regulator assembly.<br />
3. Remove three screws on rear panel.<br />
4. Remove assembly from ventilator. See Figure 8-8<br />
Blender Removal<br />
1. Remove all hoses and wiring connected to the blender.<br />
2. Loosen allen screws of knob located on the front of the ventilator. Remove<br />
knob. See Figure 8-9.<br />
3. Remove three screws located behind the knob. See Figures 8-10 and 8-11<br />
4. Remove blender from unit.<br />
5. To install, reverse order of removal.<br />
Exhalation Valve Removal<br />
1. Remove all hoses and wiring connected to the valve.<br />
2. Remove three screws located on mounting plate. See Figure 8-12.<br />
3. Remove Exhalation Valve from the ventilator.<br />
4. To install, reverse removal procedure.<br />
L2342 Revision B November 2004