TouchWare for Windows User's Guide - Touch Screens Inc.

72 TouchWare for Windows User's GuideBefore installing TouchWare, make sure all touchscreen monitors areconnected and operational. The install program will search for availableCOM ports and touchscreens and configure only the number of touchmonitors found during installation.Note: If you have previously loaded TouchWare, you must completely uninstallthe software and reboot your system prior to reinstalling.To install TouchWare for multiple touchscreen support:1. Begin installing TouchWare. If necessary, see the instructions in the “InstallingTouchWare” section on page 13 and then return to this page.2. When you see the Select Installation Type screen, select Custom Install for Oneor More Touchscreens. Click Next.3. On the Default Calibration Type screen, select the Default Calibration formatfor your system: either 2-point or 5-point. Click Next.4. On the Select Number of Touchscreens screen, select Multiple touchscreens.Click Next.The subsequent Multiple Touchscreen Search should produce details on alltouchscreens active and connected to your system. If the install program failsto find all your touchscreens, check the connections, reboot your system,uninstall TouchWare, then begin the install again.5. On the Select Destination Location screen you can choose to install to adifferent directory. For multiple monitor setup, we recommend you accept thedefault location.6. On the Multiple Touchscreen Configuration screen, set how the desktop appearson the multiple monitors.You have the following options:• Mirrored monitors – each monitor displays the same image• Tiled monitors – each monitor displays a portion of the same imageExamples of mirrored and tiled monitors are shown below.