COUPLINGS

• Centering and finishing in flange bore drillingIf customers are planning to apply bore diameter processingusing pilot bore items by themselves, the instructions belowshould be followed: Centering SHPANNRING specificationAccording to Figure A, check thecenter run-out of each size by theflange hub outer diameter. Adjustthe chuck to achieve the followingaccuracy and finish the inner diameter.d0.020.02Finish as illustrated in Figure B whenprocessing to apply the locking methodaccording to SPANNRING.6.3ESERVO FLEXSFSChuckFlange1.6C 0.5C 0.5C 0.81.6R 0.20.20.715°• Combination of standard bore diameterDetails of the E portionA type using a friction lock for mounting on the shaftThe combinations of the standard bore diameter of (SFS-£S/W/G-£M-£M) are as follows:SFS-06Standard borediameter d1 [mm]Standard bore diameter d2 [mm]12M 14M 15M 16M 20M 22M 25M 28M 30M 35M12M 14M 15MSFS-08Standard borediameter d1 [mm]Standard bore diameter d2 [mm]12M 14M 15M 16M 20M 22M 25M 28M 30M 35M15M 16M 20M 22MSFS-09Standard borediameter d1 [mm]Standard bore diameter d2 [mm]12M 14M 15M 16M 20M 22M 25M 28M 30M 35M25M 28M SFS-10Standard borediameter d1 [mm]Standard bore diameter d2 [mm]12M 14M 15M 16M 20M 22M 25M 28M 30M 35M25M 28M 30M 35MSFS-12Standard borediameter d1 [mm]Standard bore diameter d2 [mm]12M 14M 15M 16M 20M 22M 25M 28M 30M 35M30M 380 38035MStandard bore diameter d2 [mm]SFS-1412M 14M 15M 16M 20M 22M 25M 28M 30M 35MStandard bore diameter d1 [mm] 35M * The bore diameters with value or marked are supported as standard bore diameter.* The permissible torque of small bore diameter indicated in the column with value is limited by the shaft locking mechanism. The value indicates its operating torque [N·m].The latest CAD data can be downloaded from our website. http://www.mikipulley.co.jp/COUPLING_E_22_41new.indd 33CADAtención al Cliente - 902 208 608The CAD mark indicates that CAD data is available by CD-ROM.The CAD fi le No. represents the fi le name in the CD-ROM.339/15/10 4:23 PM