Programming Manual

LNC-MILLG83 Peck Drilling Cyclerepetion times; otherwise procedure ends;11. In G91 mode, argument R specifies the distance between R point and thestarting point; argument Z specifies the distance between hole bottomposition and R point; if K is specified ( > 1), after each drilling process (steps2~9) the hole position will migrate according to specified X, Y and thencontinue next drilling process12. The difference between G73 and G83 is that the retraction amount of theformer is set by system parameter #0150,and the latter will return to R pointeverytime.IllustrationWork BreakdownStarting pointR pointG83 (G98)Retract toStarting pointWork BreakdownG83 (G99)Starting pointR pointRetract toR pointqdqdqdqdqqZ pointZ pointLNC Technology Co., Ltd. 101