Programming Manual

LNC-MILLG53 Rapid Positioning of Machine Coordinate SystemG53 Rapid Positioning of Machine Coordinate SystemCommand FormatG53 ;Argument Instruction• AxisSpecify the name of axis being moved. It can be any combination of X, Y, Z, A,B, C or U, V, W. The only condition is that it must be consistent with the settingof current axis (the 4 th axis is set by using the parameter #0122). On thesix-axes model M600, parameters #0288 & #0289 are used to control the 5 th &6 th axes.• Target SiteMachine coordinate of the target point.Action InstructionG53 Command can be used to control and move the tool to the specified machinecoordinate. Regarding G53 Command, the tool’s move methoid is rapid feeding,and the speed can be set by parameters #1000~1003, 1122~1123. GenerallyG53 Command belongs to “non simultaneous movement”. If simultaneousmovement is needed, it can be set by parameter #0041. Moreover, G53Command is effective in single block only, and it can only be used under absolutemode (G90), it will become ineffecitve under incremental mode (G91).Note that the previously specified Tool Compensation value will be cancelledautomatically after the execution of G53.LNC Technology Co., Ltd. 43