Programming Manual

LNC-MILLG76 Fine Boring Cycle7. In G98 mode, fast return to the starting point; In G99 mode, fast return to thecoordinate of R point;8. Tool migrates, return to the original hole coordinate (reverse actions of step6);9. Disable spindle positioning mode, and the spindle rotates;10. If K is specified ( > 1) , repeat steps 2~9 until obtaining specified times ofboring cycle; otherwise procedure ends;11. In G91 mode, argument R is to specified the distance between R point andthe starting point; argument Z specifies the distance between hole bottomposition and R point; if K is specified ( > 1), after each boring procedure(steps 2~9), the hole position will have a incremental offset according tospecified X, Y, and then continues boring process.LNC Technology Co., Ltd. 75