Programming Manual

LNC-MILLG54~G59 Manufacturing Coordinate System SelectionG54~G59 Manufacturing Coordinate System SelectionCommand Format⎡G54;⎤⎢ ⎥⎢G55;⎥⎢G56;⎥⎢ ⎥⎢G57;⎥⎢G58;⎥⎢ ⎥⎢⎣G59; ⎥⎦Action InstructionSix G codes (G54 to G59) applied in the workpiece coordinate system representsix different coordinate system which can be used in accordance withmanufacturing needs.The origin offset of each coordinate system can be set through〈OFFSET〉〈coordinate system setting〉; For more information, refer to the operation manual;Moreover, it can also be set by G10 Command, for more information about thisrefer to G10 Command instruction.The relationship among each coordinate system is shown as follows: : (Thedefault coordinate system is G54 after the system is boot.)G55G54G55 OffsetG56G54 OffsetG56 OffsetG57 OffsetG5700 Work coordinate00 OffsetG58 OffsetG58Zero pointG59 OffsetG5944 LNC Technology Co., Ltd.