Programming Manual

LNC-MILLG88 Boring Cycle8. If K is specified ( > 1), repeat steps 2~7 until obtaining specified boringrepetition times; otherwise procedure ends;9. In G91 mode, argument R specifies the distance between R point and thestarting point; argument Z specifies the distance between hole bottomposition and R point; If K is specified ( > 1), if K is specified ( > 1), after eachtapping process (steps 2~7), the hole will do incremental offset according tospecified X, Y and then continue next boring process..10. The difference between G86 and G88 is that the latter can specify the dwelltime at the hole bottom.IllustrationWork BreakdownStarting pointR pointG88 (G98)Retract toStarting pointWork BreakdownStarting pointR 點G88 (G99)Retract toR pointPZ pointPZ pointLNC Technology Co., Ltd. 141