Programming Manual

LNC-MILLG101 Linear Mode Multi-hole Manufacturing Cycle5 : tapping cycle (G74/G84, specified by argument K); if parameter #0810 be 1,it’s rigid tapping; if parameter #0810 be 0, it’s normal tapping.• Q__Depth of feed each time (mm)(argument M be 1~4);In tapping mode (argument M be 5), it’s for assigning Metric thread (M, MF) orBritish thread (BSW, BSF), 0 denotes Metric, and 1 denotes British.• R__Manufacturing cycle return R point (mm).• S__Spindle speed (RPM).• T__Dwell time at hole bottom (1/1000 sec), minimum unit, decimal numbers arenot allowed.• V__Retrace amount per manufacturing (mm)(argument M be 1~4);In tapping mode (argument M be 5), it’s for assigning the pitch.• X__Reference point of X-axis (mm).• Y__Reference point of Y-axis (mm).• Z__Coordinate of the hole bottom (mm).164 LNC Technology Co., Ltd.