Programming Manual

LNC-MILLG82 Drilling Cycle5. In 98 mode, fast return to the starting point; In G99 mode, fast return to Rpoint;6. If K is specified ( > 1), repeat steps 2~5 until reach specified drilling iterationtimes; otherwise procedure ends;7. In G91 mode, argument R specifies the distance between R point and thestarting point; argument Z specifies the distance between hole bottomposition and the R point; If K is specified ( > 1), after each drilling process(steps 2~5) the hole will migrate according to specified X, Y and thencontinues next drilling process.8. The difference between G81 and G82 is that the latter can specify the dwelltime at the hole bottom.IllustrationWork BreakdownStarting pointR pointG82 (G98)Retract toStarting pointWork BreakdownStarting pointR pointG82 (G99)Retract toR pointPZ pointPZ pointLNC Technology Co., Ltd. 93