IronPort - daily management guide - AsyncOS 7.6.1

Managing the Configuration File
8-38
Figure 8-25 Loading a Configuration File
Cisco IronPort AsyncOS 7.6 for Email Daily Management Guide
Chapter 8 Common Administrative Tasks
Regardless of the method, you must include the following tags at the top of your configuration:
... your configuration information in valid XML
The closing tag should follow your configuration information. The values in XML syntax are
parsed and validated against the DTD (document type definition) located in the configuration directory
on your Cisco IronPort appliance. The DTD file is named config.dtd. If validation errors are reported
at the command line when you use the loadconfig command, the changes are not loaded. You can
download the DTD to validate configuration files outside of the appliance before uploading them.
In either method, you can import an entire configuration file (the information defined between the
highest level tags: ), or a complete and unique sub-section of the configuration file,
as long as it contains the declaration tags (above) and is contained within the tags.
“Complete” means that the entire start and end tags for a given subsection as defined by the DTD are
included. For example, uploading or pasting this:
0