IronPort - daily management guide - AsyncOS 7.6.1

Managing Reports
Notes on Reports
2-44
Incoming Mail Summary
Internal Users Summary
Outgoing Destinations
Outgoing Mail Summary
Outgoing Senders: Domains
Sender Groups
System Capacity
TLS Connections
Cisco IronPort AsyncOS 7.6 for Email Daily Management Guide
Chapter 2 Using Email Security Monitor
Outbreak Filters
Virus Types
Each of the reports consists of a summary of the corresponding Email Security Monitor page. So, for
example, the Content Filters report provides a summary of the information displayed on the Monitor >
Content Filters page. The Executive Summary report is based on the Monitor > Overview page.
Content Filter reports in a PDF format are limited to a maximum of 40 content filters. You can obtain
the full listing via reports in a CSV format.
Note To generate PDFs in Chinese, Japanese, or Korean on Windows computers, you must also download the
applicable Font Pack from Adobe.com and install it on your local computer.
Setting the Return Address for Reports
Managing Reports
To set the return address for reports, see the “System Administration” chapter in the Cisco IronPort
AsyncOS for Email Configuration Guide. From the CLI, use the addressconfig command.
You can create, edit, delete, and view archived scheduled reports. You can also run a report immediately
(on-demand report). The following report types are available: Content Filters, DLP Incident Summary,
Executive Summary, Incoming Mail Summary, Internal Users Summary, Outgoing Mail Summary,
Sender Groups, and Outbreak Filters. Managing and viewing these reports is discussed below.
Note When in Cluster Mode, you are unable to view reports. You may view reports when in machine mode.
The Monitor > Scheduled Reports page shows a listing of the scheduled reports already created on the
appliance.
OL-25138-01