E - VAE ProSys sro

3.3 Instructions for Mounting and InstallationRemove the terminal from the packaging. Items supplied are:− the MT− mounting elements• two for MT-40 and MT-45• four for MT-30• six for MT-60• eight for MT-91 and MT-120− this manual where applicableFitting can be directly into− cabinet doors or− operating panels.Selection of fitting position according to:− optimal height for operator− good lighting, so that the display is easy to read− suitable ventilation to be used in case of high ambient temperatures.− Avoid mounting in the immediate vicinity of switchgear or power converters.Prepare an opening with the following dimensions:Device Width Height Fitting depth Thickness/materialMT-30 138 +1 mm 106 + 1 mm 105 mm approx. max. 18 mmMT-40, MT-45 138 +1 mm 138 + 1 mm 125 mm approx. up to 40 mmMT-60283 ± 0.5 mm 139 ± 0.5 mm 110 mm approx. max. 18 mmConst. variation IMT-60283 ± 0.5 mm 79 + 0.5 mm 110 mm approx. max. 18 mmConst. variation II+ 3 holes(see diagram)MT-91 300 mm 180 mm 130 mm approx. max. 10 mmMT-121 300 ± 0.5 mm 180 ± 0.5 mm 120 mm approx. max. 8 mmExchange the labelling strip before the installation:The labelling stripes are to be changed at the rear of the device.• Pull out paper-tapes carefully with a tweezers. Do not press into the slot with a sharp tool because the front foilwill be damaged!• Inscribe the paper-tapes• Carefully insert again (at an angle of approx. 45 degrees):• in doing this, do not apply any pressure on the front panel• angling the corners simplifies insertionIf you produce new stripes, these must correspond in size to the original stripes (see appendix, "Labelling strips").They may not protrude over the rubber seal.E24Process display and control/ Device Manual/ Issue: 07.01