E - VAE ProSys sro

6.1.2 Address declaration for T200 in PLCPlus-GThe addresses of the memory areas must be declared as follows:Address declaration(MWXXX,YY)(LUMWXXX,YY)RangeDeclaration of the word flagsDeclaration of the word flags with Link number and UnitnumberLUXXXYY= Link number= Unit number= Group number= Channel number0...20...F (hexadecimal)0...1270...15For the text terminals, addressing with L, U is possible only from Version 2.79; previous versions can address onlythe directly connected station. Only 10 characters are at the disposal! All configuration addresses must have the same values L, U.Reaction of the terminals:If L, U are not declared in the address then Link number and Unit number are set via the substation number of thedevice (DIL resp. configuration menu):UST-Nr = 1 L, U are F, F (connected station)2 1, 0 Station 03 1, 1 14 1, 2 2etc.In this case, only one line can be addressed.If LU are declared in the address with 00 then the connected station is addressed.Examples:UST-Nr (MW000,01) (00MW000,01) (17MW000,01)1 LU = FFLU = FFLU = 17connected station connected station2 LU = 10 LU = FFLU = 17connected station3 LU = 11 LU = FFLU = 17connected station4 LU = 12 LU = FFconnected stationLU = 17Process display and control/ Device Manual/ Issue: 07.0193E