General Index - National Roofing Contractors Association

17. Ineligible structure or building use Roof installed over cold storage or freezer compartments. Residential buildings; there may be other buildings with specialrequirements.18. Pre-construction notice andapproval requirementsNone required.Contractor must complete project approval form and forward toBondCote Roofing Systems for approval prior to job start.Contractor must provide roof layout plan and all details toBurke prior to job start; Burke approval required.19. Approved, authorized, or licensedrequirementsNo Yes Yes20. Job inspection policy No on-site inspections. BondCote technical field representative makes inspectionsafter completion prior to issuing warranty; BondCote willinspect prior to and during application for Αnew contractors≅and on large or difficult installations.Burke field service employees make inspection prior to, during,and after application prior to issuance of warranty as well astwo years later; $350/day charge plus expenses for re-inspectionsonly.21. Contractor’s post-installationobligationNone; material-only warranty.Contractor obligated to make repairs to workmanshipdeficiencies for two years.Contractor oblibated to make repairs to all leaks and materialsand workmanship for two years.22. Backed by named insurance orsuretyNo; Bitec indicates that it does not carry insurance covering itswarranty obligations.No; BondCote indicates that it does not carry insurancecovering its warranty obligations.No; Burke indicates it does carry insurance that covers itswarranty obligations.23. Issuing entity manufacturesand/or sells productsBitec manufactures and sells the product.BondCote Roofing Systems manufactures and sells theproduct.Burke manufactures and sells product.24. Conditions for renewal orextensionNo renewal provision.NoneWarranty may be extended for five years. If owner notifiesBurke at the time of issuance of original warranty of intent toseek an extension, there is no fee for inspection. If ownerseeks extension later, owner pays $350/day plus expenses forinspection. Burke makes inspection; owner pays for worknecessary to bring roof to condition acceptable to Burke andpays fee for extension.25. Assignability Non-transferable. Warranty solely benefits the first consumer,purchaser or owner of Bitec Mineral Design membrane; itcannot be transferred in any form to anyone.Not assignable without written permission from BondCoteRoofing Systems.No restrictions stated.26. Special features/conditions Claims require proof of purchase of the Mineral Designmembrane. Owner must provide Bitec with a receipt whichcan be traced to a Bitec distributor who sold the MineralDesign membrane.Bitec has ninety days after receipt of notification to make,or cause to be made repairs or replacements covered underwarranty. Prior to expiration of the ninety day period, Bitec willnot be liable for any cost of repair or replacement unless Bitechas given written approval of the repair or replacement ofMineral Design membrane.Warranty may not be changed or modified. No one,including any representative or employee of Bitec has theauthority to assume any additional liability for Bitec inconnection with Mineral Design membranes.BondCote Roofing Systems has no obligation under thewarranty without owner's signature accepting the warranty inlieu of all other remedies and the return of signed copy toBondCote Roofing Systems; the extended warranty has thesame limitations as the original ten-year warranty. Owner shallbe responsible for the cost of investigation if any leaks aredetermined not to be covered under warranty.No representative of Burke has authority to make anyrepresentation or promises except as stated in warrantydocument27. Executed by owner Warranty registration card must be completed and sent toBitec within 10 days of membrane installation.Yes (See Special Features/Conditions.) No581