hybrid operation, maintenance and warranty manual - Steyr Motors

Check following parameters on screen „HCU” before continuing with start- procedure:- E-Mode ready= red illustrated,- D-Mode ready= green illustrated,- HCU o.k.=green illustrated- GENER.= green illustrated,- BATTERY= between min.45V/max.57V .NOTE: If parameters are not displayed as described above, follow chapter 4.TROUBLE SHOOTING or contactyour authorized STEYR MOTORS marine DEALER.5. Turn ignition key into position "START„ and hold in this position until "starting" of engine, but under nocircumstances hold in this position for more than ten seconds.If engine does not start, release ignition key momentarily and repeat starting procedure.OFFONSTART11-039ATTENTION: If starting of Hybrid Engine in D-Mode is not possible, in emergency cases conventionalstarter-motor can be used for start- up.To start the Hybrid- engine with conventional startermotor refer to chapter 2.5 (STEYR MOTORS recommendsto use conventional starter- motor only in emergency- cases. If conventional starter-motor is used, contactauthorized STEYR MOTORS DEALER for fault investigation as soon as possible)6. As soon as engine starts, release ignition key. The audible alarm will stop when normal oil pressure hasbeen reached.ATTENTION: If engine fails to start within one minute and/or repeated attempts, try to start in emergency caseswith conventional startermotor (proceed according chapter 2.5) or contact your STEYR MOTORS Marine dealer.Never turn ignition key to position "START" when engine is running.Z001045-0_1_March 2012 - 17 -